| Top rated |
Canopy Hinge Location Prep115 views
(1 votes)
|
|
Canopy latched with lock tumbler visible148 views
(2 votes)
|
|
Rib and Spar Fitting79 viewsBoth pieces trimmed per the manual
(2 votes)
|
|
Baffling Support and seal surface59 viewsUsing duct tape the baffling and started mount are used as a mold for a bridge piece that will both secure the two baffling halves and provide a smooth surface for the silicon seal.
(2 votes)
|
|
Gussets Prepared95 viewsThe gusset areas get reinforcement laminates before the gussets are laminated in place.
(2 votes)
|
|
Other view102 views
(2 votes)
|
|
Installed less door84 viewsHere is a side view that shows the modified door mounting bracket. A section was made removable so the caliper could be removed for maintenance without removing the wheel and axle as is common with the Matco Brakes.
(2 votes)
|
|
Axle and torque plate82 viewsHere you can see the axle with the torque plate, spacer, heat shield and door mounting bracket.
(2 votes)
|
|
Ramp mold overview73 viewsThe ramp that will be bonded to the upper cowl will be laminated against a foam mold. The gap between the NACA scoops is faired with a smooth curve.
(2 votes)
|
|
56 views
(2 votes)
|
|
Rudder Pedal Center Support Bracket130 views
(3 votes)
|
|
Induction air valve169 views
(2 votes)
|
|
|
|
