Most viewed - Glastar |

Installed less door2352 viewsHere is a side view that shows the modified door mounting bracket. A section was made removable so the caliper could be removed for maintenance without removing the wheel and axle as is common with the Matco Brakes.
|
|

Caliper installed2305 viewsThis view shows the caliper installed with the phenolic heat shield and the door mounting bracket.
|
|

Header tank lower1340 views
|
|

Nose gear door aft hinge mount1287 views
|
|

Vertical Fin Bulkheads1212 viewsThe bulkheads were cutout and fit to the vertical fin and then the foam was sealed with a Q-cell mixture and laminated. The aft bulkhead had an extra 2 layers applied to the aft face to keep it straight while installing.
|
|

Fresh air NACA inlets and nozzles1175 views
|
|

Hydraulic Pump mount1112 views
|
|

Cowling Vertical Hinge Inside view1106 viewsThe inside view of the hinge installation.
|
|

Rear windows fit1097 views
|
|

Preparing to install the firewall and engine mount1051 views
|
|

Header tank side1022 views
|
|

Exit air deflector996 views
|
|
124 files on 11 page(s) |
1 |
 |
 |
 |
 |
 |
 |
 |
 |
|