| Category |
Albums |
Files |
|
|
5 |
58 |
|
|
|
2 |
26 |
|
| MODsVarious MODs performed on customer's aircraft |
|
2 |
19 |
|
| 103 files in 9 albums and 5 categories with 0 comments viewed 10139 times |
| Random files |
Aileron Belcrank Bearing Drilled60 viewsWith the rod-end bearings bolted in place and the bearing wrapped with tape you can back drill through the first set of holes to complete the prep for riveting.
|
|
Firewall Overview100 viewsA view of the firewall after the aft seams were installed.
|
|
Horizontal top panel supported56 viewsAfter the table is leveled the supports made per the instructions can be set on the table and the horizontal panel can be clamped and hot glued into position.
|
|
Level the table before setting the supports64 views
|
|
Exit air deflector249 views
|
|
Ramp Fitting48 viewsThe ramp was removed from the mold, trimmed and set in place for final fitting before bonding to the upper cowling.
|
|
Canopy Latched into fuselage receptacles158 views
|
|
Cowling Vertical Hinge Inside view76 viewsThe inside view of the hinge installation.
|
|
| Last additions |
171 viewsMay 08, 2007
|
|
Left side routing157 viewsMay 08, 2007
|
|
Oil Cooler mount installed144 viewsMay 08, 2007
|
|
Fuel pump cooling shroud191 viewsMay 08, 2007
|
|
Firewall and engine mount installed208 viewsMay 08, 2007
|
|
Preparing to install the firewall and engine mount225 viewsMay 08, 2007
|
|
routing217 viewsMay 08, 2007
|
|
Exit air deflector249 viewsMay 08, 2007
|
|
